Although our IoT coin counter was finally done, we were not through with our task. The next task was to… Read more Coin Counts Promo Video
After properly integrating the coin acceptor into the main program, the next step was to power everything. There were multiple… Read more Addition of Voltage Regulator
Just because there has not been a post for weeks does not mean that we have not been working diligently… Read more Coin Acceptor Fully Set Up
We finally received the coin acceptor today to profile the coins individually. The process of programming the coins was not hard… Read more Hands on the Coin Acceptor
Unfortunately, we were not able to get the LDC1000 working properly, and even after working with TI engineers, Trey and… Read more Project Scope Changes
After placing the order of 3-D printing the Insignia plate with i-SOLIDS’s hub, it took about 4 days to fully… Read more Team TAJ’s Insignia Plate has finally been 3-D printed!
Hello dear readers! Sorry for the absence in updating the blog, I have been busy with life in general plus… Read more 3-D model of Team TAJ’s Insignia Plate and the process of hollowing it out
Originally, I was going to wait till we were able to get the LDC1000 working before adding extras to the… Read more Webpage Complete! (Part 2)
We finally completed the webpage! Currently it holds information about the two different teams’ monetary value of coins counted, as… Read more Webpage Complete!
Below are pictures of the current LDC1000 with MSP430F5529 LaunchPad setup with a different coil than the one included with the… Read more Current Coil Setup